Owner Information

OWNER'S MANUAL
BOAT LIFT MAINTENANCE
SAFETY
WARNINGS
LIFT OPERATION
DRIVING BOAT ON TO LIFT

BOAT LIFT MAINTENANCE

CABLES

Inspect all cables before each use.

Rinse cables and rest of boat lift with fresh water after each use.

Cable has a limited operating life and may need to be periodically replaced.

If signs of wear or damage appear, replace immediately.

DRIVE UNITS

Keep worm gear, drive gear, and all bearings or bushings greased on a monthly basis.

Make sure to grease all grease fittings on gear plate including fitting located between plate and large gear, on a regular basis.

Make sure pulley belt is tightened.

Check all set screws on bearings regularly.

PULLEYS

Inspect pulleys on a monthly basis for wear.

Make sure all nuts and bolts are tight.

RUNNERS

Runners will need periodic replacement.

Inspect for wear and rotting.

SAFETY

THINGS TO REMEMBER

ALWAYS TURN OFF POWER AT MAIN BREAKER TO PREVENT OTHERS FROM USING YOUR LIFT

KEEP ALL PEOPLE AWAY FROM LIFT WHILE IN OPERATION

DO NOT LET CRADLE BEAMS TOUCH BOTTOM, THIS WILL RESULT IN THE CABLES BECOMING SLACK AND REWINDING IMPROPERLY

INSPECT ALL CABLES AND PULLEYS BEFORE OPERATING

VESSEL MUST BE CENTERED APPROPORIATE TO WEIGHT, NOT LENGTH, TO ENSURE PROPER OPERATION OF YOUR BOAT LIFT

BE SURE TO DISCONNECT DOCK POWER TO BOAT BEFORE OPERATING

REMEMBER TO REMOVE DRAIN PLUG AFTER BOAT IS OUT OF WATER

KEEP LIFT GREASED

WARNING!

FOR USE BY ADULTS ONLY

KEEP HANDS AWAY FROM ALL MOVING PARTS

BOAT LIFTS ARE NOT INTENTEND TO LIFT PEOPLE

DO NOT RIDE IN BOAT WHILE USING LIFT

NEVER LEAVE RUNNING UNATTENDED

WHEN NOT IN USE TURN OFF YOUR POWER SUPPLY

DAMAGE OR INJURY COULD RESULT IF LIFT IS LEFT RUNNING

NEVER LET CRADLE BEAMS TOUCH THE BOTTON ALLOWING CABLES TO BECOME SLACK

MAKE SURE NO ONE IS UNDER OR STANDING ON THE LIFT DURING OPERATION

DEATH OR BODILY INJURY COULD RESULT IF YOU IGNORE ANY OF THE ABOVE WARN1NGS

OPERATION

LOWERING YOUR BOAT LIFT

After inspecting your lift:

(Remember to insert drain plug in your boat)

Turn main power on to your lift.

Lower your lift into the water.

Do not ride in boat while lowering or raising your lift.

Do not let cradles touch the bottom.

Make sure lift and boat runners are clear of boat hull before starting your engine.

After backing your boat off of the lift, we recommend you lift your cradles out of the water.

DRIVING BOAT ON TO LIFT

Lower lift sufficiently so your boat will float over the cradles.

Do not let cradles touch the bottom.

Slowly position your boat over the cradles to desired position.

Use your PVC guide posts to center your boat on the lift.

Raise lift until the weight of the boat is on the wood runners.

Inspect the boat to insure proper alignment.

Make necessary adjustments.

Once the boat is in position, continue to lift the boat for storage.

Do not ride in boat while lowering or raising your lift.

Remove drain plug to prevent excess weight from water accumulation.

Turn power off at main breaker after each use.

BOAT LIFT MAINTENANCE
SAFETY
WARNINGS
LIFT OPERATION
DRIVING BOAT ON TO LIFT